Trimetric TM-2030-A Battery Monitor System Set
- Brand: Bogart Engineering
- Product Code: TM-2030-A
- Availability: In Stock
Trimetric TM-2030-A Battery Monitor System Set
- Trimetric TM-2030-A
- 500A DC Shunt
- 50Ft 22 Guage 4 Wire cable
- Wiremold Double Gang Box for 2348-2
The TM 2030 is intended to help maintain battery systems for 12V to 48V deep cycle batteries, such as ones found in RV’s or off grid homes, which are regularly charged and discharged. It measures the rate of energy going in or out of your batteries so you can check your charging systems and see how much energy each of your appliances use. This is a big help when you’re trying to conserve energy. The Trimetric will help you keep track of how charged or discharged your batteries are. It will let you discover if your charging systems are charging to the proper voltage, which is important for maximizing your battery life. The monitor will also tell you the number of days since the main battery system was fully charged, so if it hasn’t been charged recently you can perform extra charging if necessary to help maintain the capacity of your batteries. The TM-2030 also can measure the voltage only of a second battery set, such as the starting battery, or solar voltage input to a charge controller.
The main difference between this model and the older TM-2025-A is that the TM-2030-A is capable of working in tandem with the new Bogart Engineering SC-2030 PWM solar charge controller. When the two units are used together, it increases the performance of the charge controller and can adjust the output to a level that is better suited to your batteries current state of charge.
Battery Life SaverBattery Desulfator for 48V Electric Vehicles or Battery BanksBLS-48ABLS-48A is designed for use in 48 volt renewable energy battery banks or use with battery powered vehicles (Use the (BLS 48N) for 48 volt golf carts). Ideally mounted full time to constantly keep the batteries in optimum condition, the BLS-48A comes with 3/8″ eye rings for attachment to the battery terminals..
The MidNite Solar Surge Protector Device (MNSPD) is a Type 1 device per UL1449 rev3. It is designed for both AC and DC systems and provides protection to service panels, load centers or where the SPD is directly connected to the electronic device requiring protection. The DC SPD will work well on all DC circuits up to 300 volts as well as any 120/240 VAC circuits. The difference between the A..
50mV/500amp includes taptite mounting screws. Has two 8-32 tapped holes on one end to attach a bus bar. This is the industry standard shunt...
