The MidNite Solar Surge Protector Device (MNSPD) is a Type 1 device per UL1449 rev3. It is designed for both AC and DC systems and provides protection to service panels, load centers or where the SPD is directly connected to the electronic device requiring protection. The DC SPD will work well on all DC circuits up to 300 volts as well as any 120/240 VAC circuits. The difference between the A..

The MidNite Solar Surge Protector Device (MNSPD) is a Type 1 device per UL1449 rev3. It is designed for both AC and DC systems and provides protection to service panels, load centers or where the SPD is directly connected to the electronic device requiring protection. The DC SPD will work well on all DC circuits up to 600 volts as well as any 120/240 VAC circuits. The difference between the A..

The Whiz Bang Jr is a current sense module that attaches to the standard 50mv / 500A Shunt and wires into the Classic and KID Charge controllers to give Amperage readings from the shunt. This allows for EndAmps to function based on System amps or Classic amps.Type 1 environmental ratingWarranty – 5 yrs.Made in the USA..

Midnite SolarPanel Mount Circuit Breaker15A, 150VDCMidnight’s breakers are rated to break the full rated load at the rated voltage repeatedly, with NO DAMAGE. Always use a properly sized breaker for disconnecting. All MidNite circuit breakers are rated for 100% continuous duty.15 amp 150VDC Panel Mount Breaker, 10,000 AICUL & CSA Listed1/4" studs 3/4" wide..

Battery Fuse Disconnector 250AApplication ScopeThunderVolt fuse switch disconnector is applicable to high short circuit current circuit with AC 50(60)Hz, voltage up to 660V and rated working currentup t0 630A. Fuse Switch disconnector possesses upper and lower end input and output structure. Lead in equipment with knife-edge and arcextinguishing equipment, and also can be operated with load. It is..

The MidNite Solar MNB REAKER PROTECTOR is for use with either the MidNite Solar MNEDC175 175A 125VDC Panel Mount Breaker or MNEDC250 250A 125VDC Panel Mount Breaker.The MidNite Solar MNB REAKER PROTECTOR will keep the 175 or 250 Amp Breaker from being accidentally hit...

Front panel, single pole mount with stud terminals on the back. Ring terminals required.Safety - Panel mounted hydraulic-magnetic type breakers. Hydraulic-magnetic type breakersEfficiency - Works with single pole mount. Can be used for input, output or load circuits.User Friendly - Easy installation and multiple uses...

The BR-DC175 and BR-DC250 are the same DC breakers installed in the MidNite and Magnum Panels system enclosures, and included with the MPX extensions. These breakers function as the inverter’s DC disconnect switch and can be used as the battery-to-inverter circuit protection in most installations. These breakers are specifically designed and tested to work with MidNite Solar and Mag..

The HYDROVOLT battery tester us a heavy-duty, chemical-resistant hydrometer which is direct-reading and accurate at all eletrolyte temperatures. Its advanced design imcorporates important practical features which simplify battery servicing as never before.- Handy compact size for use with hard-to-get-at batteries- Large, easy-to-read scale with quick-check colored sectors- Readings independent of ..

MNBCMS MidNite Battery Capacity MeterThe “S” version (MNBCMS) of the meter has an additional short wire attached. This wire is the “Switched lead” This feature allows the LEDS to be turned off while retaining the Battery Care memories. This wire should be connected through a fused switch to Battery positive. This is usually the ignition switch of a vehicle, but can also be any type of push button,..